|
 |
The following guide describes all the steps required for contractors to perform during the employment training program.
The employment training process follows a flowchart which begins with the orientation which discloses all the procedures and requirements the job entitles. The next steps involves the application, the review of such document. This document is then reviewed by application review units which according to the data provided will determine contracting eligibility.
After determining eligibility these preliminary applications are assigned to an Employment Training Regional Office, then an analyst schedules a visit to the contractor's site. The same analyst then visits the site and provides the contractor the application for funding and technical assistance if required.
After these procedures are completed the applicant must submit the application for funding to the appropriate office. If the program analyst determines that the application is good enough to be financed or funded then the 'agreement paperwork' is developed and approved at a meeting allowing the funded training to begin.
Under a labor compliance program these steps need to be done prior to construction. As described above, a pre-construction conference must be held before contractors and subcontractors start working on the project and accepting bids. A district representative must address and in most cases answer questions about procedures, wage determinations, general requirements, apprenticeship requirements, record keeping, form discussion and filling, etc.
In such pre-construction meeting, information about paying training fees and giving proper notice to use registered apprentices should also be addressed. Currently there are labor codes which provide instructions about employing apprentices, etc. These conferences are required to keep a record about the federal and state labor laws discussed in form of a checklist.
As you can see the steps outlined above describe how contractors can acquire funding to provide employment training programs. There are several other factors which must be accounted for but the most important ones have been mentioned. It is important for contractors and subcontractors to comply with all the regulations necessary according to each state where the project is being planned, after all these programs will provide employees the skills and knowledge required to execute and finalize such tasks on time and on budget.
Category: Education and TrainingA Guide To Employment Training was written by:Author:Ivan Cuxeva JrAdded: Sat, 12 May 2007 02:50:13 -0400 This Article Has Been Read 417 times View all Ivan Cuxeva Jr's articlesAbout the Author: SearchOptimizationSEO.com is a blog by a Brisbane SEO. It includes a section on SEO basics as well as more general SEO articles. |
More Articles About Education and Training
Not What You Were Looking For?
 Moxie Drive Expressions
 Submit Articles
 Contact us
Add us to favorites
Hint - Hold "T" button down and right click to open Sphinn and Subbmitt in a new window. 
|